Sonnet-technologies Echo Express SEL 10GbE Manuel d'utilisateur télécharger pdf (Page 10)

Chapter 5 – Verifying Adapter Recognition Using System Report

Figure 2

Figure 3

Confirming Thunderbolt and the 10GbE Controller

are Recognized

1. With the Echo adapter powered and connected to the

computer, turn on the computer. Note that if there are

any other Thunderbolt devices connected between the

Echo adapter and your computer, they must also be

powered for you to perform the following steps.

2. From the Apple menu, select About This Mac; the

System Information application will launch.

3. When the About This Mac window opens, click More

Info; a summary of speciﬁcations will appear.

4. Click System Report; a full report window will appear.

5. In the System Report window, click Thunderbolt under

the Hardware header in the left column (Figure 2).

6. In the top right column under the Thunderbolt Device

Tree header, you will see the computer listing, with

“Echo Express SEL” appearing below it (Figure 2).

7. Click PCI Cards under the Hardware header in the left

column (Figure 3).

8. At the top of the right column, the installed 10GbE card

is listed, identiﬁed as an Ethernet Controller; detailed

information appears below. You will see “Yes” next to

Driver Installed and Tunnel Compatible (Figure 3).

Support Note: If you do not see “Echo Express SEL”

listed, disconnect and reconnect the Thunderbolt

cable between the computer and Echo Express SEL. Note

that it is not necessary to shut down the computer before

disconnecting and reconnecting the cable.

1 2 ... 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Sonnet-technologies Echo Express SEL 10GbE Manuel d'utilisateur Page 10