Sonnet-technologies Echo Express III-R Mobile Rack Kit Manuel d'utilisateur télécharger pdf (Page 7)

Chapter 3 – Mobile Rack Kit and Device Installation Steps

1. Remove your Echo Express III-R Thunderbolt-to-PCIe card expansion

chassis from its packaging, or (after powering down and disconnecting

attached cables) from the rack into which it is installed. Set it on a ﬂat,

level surface.

2. Using a Phillips screwdriver, remove and set aside the four screws

securing the Echo chassis’ inner assembly to its rackmount enclosure

(Figure 1).

3. Remove the inner assembly from the enclosure by gently gripping the

faceplate by its edges and pulling (Figure 1).

4. If you have not already done so, remove and set aside the six screws

securing the blank plate inside the enclosure, and then remove and

set aside the blank plate. (Figure 2).

Figure 1

Figure 2

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Sonnet-technologies Echo Express III-R Mobile Rack Kit Manuel d'utilisateur Page 7